Busheling Scrap

• Stamping Plant Qms
• Material Collection And Control Procedures

• Environmental Compliance
• Waste Management

• Chemical composition
• Origin verification
• Traceability information
• Inspection report

• UKAS accredited laboratory
• ILAC accredited laboratory

• Stamping Plant License
• Material Control Procedures

Proof of single-source busheling (press-direct collection)

• Press identifier
• Collection date/time
• Lot tracking number
• Seal/chain of custody

£3–5 million general liability

Fe <95.0%

• Violates Isri 207 Specification
• Indicates Wrong Material Source

Any piece >1mm copper, aluminum, brass detected

Zero tolerance for manufacturing contamination

>0.02% OR any visible stainless piece

Manufacturing scrap should have ZERO stainless exposure

>1.0% combined

• Lowest Combined Limit Of Ferrous Grades
• Indicates Mixed Source (Not Pure Busheling)

Any paint, oil, grease, dirt, oxide coating visible

• Busheling Must Be Factory-Clean
• Coatings Indicate Wrong Source

No traceability to specific press/facility

Manufacturing traceability required for busheling grade

Any visible

Environmental hazard

Any detectable

Hazardous materials

Evidence of mixed source or collected scrap (not busheling)

• Material Must Be Busheling (Direct From Press)
• Cannot Be Mixed/Collected Scrap

>0.5% residual moisture or press fluid visible

Excess moisture or fluid contamination unacceptable